Browsing by Subject "Hole wave functions"

Now showing 1 - 3 of 3

Open Access
Electronic and optical properties of 4.2 μm"N" structured superlattice MWIR photodetectors
(Elsevier, 2013) Salihoglu, O.; Hostut M.; Tansel, T.; Kutluer, K.; Kilic A.; Alyoruk, M.; Sevik, C.; Turan, R.; Ergun, Y.; Aydınlı, Atilla
We report on the development of a new structure for type II superlattice photodiodes that we call the "N" design. In this new design, we insert an electron barrier between InAs and GaSb in the growth direction. The barrier pushes the electron and hole wavefunctions towards the layer edges and under bias, increases the overlap integral by about 25% leading to higher detectivity. InAs/AlSb/GaSb superlattices were studied with density functional theory. Both AlAs and InSb interfaces were taken into account by calculating the heavy hole-light hole (HH-LH) splittings. Experiments were carried out on single pixel photodiodes by measuring electrical and optical performance. With cut-off wavelength of 4.2 μm at 120 K, temperature dependent dark current and detectivity measurements show that the dark current is 2.5 × 10 -9 A under zero bias with corresponding R0A resistance of 1.5 × 104 Ω cm2 for the 500 × 500 μm2 single pixel square photodetectors. Photodetector reaches BLIP condition at 125 K with the BLIP detectivity (DBLIP) of 2.6 × 10 10 Jones under 300 K background and -0.3 V bias voltage. © 2012 Elsevier B.V. All rights reserved.
Open Access
High quantum efficiency Type-II superlattice N-structure photodetectors with thin intrinsic layers
(SPIE, 2013) Ergun, Y.; Hostut, M.; Tansel, T.; Muti, bdullah; Kilic, A.; Turan, R.; Aydınlı, Atilla
We report on the development of InAs/AlSb/GaSb based N-structure superlattice pin photodiode. In this new design, AlSb layer in between InAs and GaSb layers acts as an electron barrier that pushes electron and hole wave functions towards the GaSb/InAs interface to perform strong overlap under reverse bias. Experimental results show that, with only 20 periods of intrinsic layers, dark current density and dynamic resistance at -50 mV bias are measured as 6×10-3 A/cm2 and 148 ωcm2 at 77K, respectively. Under zero bias, high spectral response of 1.2A/W is obtained at 5 μm with 50% cut-off wavelengths (λc) of 6 μm. With this new design, devices with only 146 nm thick i-regions exhibit a quantum efficiency of 42% at 3 μm with front-side illimunation and no anti-reflection coatings. © 2013 SPIE.
Open Access
Theoretical investigation of InAs/GaSb type-II pin superlattice infrared detector in the mid wavelength infrared range
(2013) Kaya, U.; Hostut, M.; Kilic, A.; Sakiroglu, S.; Sokmen I.; Ergun, Y.; Aydınlı, Atilla
In this study, we present the theoretical investigation of type-II InAs/GaSb superlattice p-i-n detector. Kronig-Penney and envelope function approximation is used to calculate band gap energy and superlattice minibands. Variational method is also used to calculate exciton binding energies. Our results show that carriers overlap increases at GaSb/InAs interface on the higher energy side while it decreases at InAs/GaSb interface on the lower energy side with increasing reverse bias due to shifting the hole wavefunction toward to the GaSb/InAs interface decisively. Binding energies increase with increasing electric field due to overall overlap of electron and hole wave functions at the both interfaces in contrast with type I superlattices. This predicts that optical absorption is enhanced with increasing electric field. © 2013 American Institute of Physics.