Browsing by Subject "High quality factors"

Now showing 1 - 4 of 4

Open Access
Metamaterial-based wireless strain sensors
(American Institute of Physics, 2009-07-07) Melik, R.; Unal, E.; Perkgoz, N. K.; Puttlitz, C.; Demir, Hilmi Volkan
We proposed and demonstrated metamaterial-based strain sensors that are highly sensitive to mechanical deformation. Their resonance frequency shift is correlated with the surface strain of our test material and the strain data are reported telemetrically. These metamaterial sensors are better than traditional radio-frequency (rf) structures in sensing for providing resonances with high quality factors and large transmission dips. Using split ring resonators (SRRs), we achieve lower resonance frequencies per unit area compared to other rf structures, allowing for bioimplant sensing in soft tissue (e.g., fracture healing). In 5×5 SRR architecture, our wireless sensors yield high sensitivity (109 kHz/kgf, or 5.148 kHz/microstrain) with low nonlinearity error (<200 microstrain).
Open Access
Observation of defect formation in metamaterials
(OSA, 2008-10) Çağlayan, Hümeyra; Bulu, I.; Loncar, M.; Özbay, Ekmel
We report subwavelength localization of electromagnetic fields within cavities based on metamaterials. Cavity resonances are observed in the transmission spectrum of a split ring resonator and composite metamaterials cavity structures. These cavity resonances are shown to exhibit high quality factors. Since the unit cells of metamaterials are much smaller than the operation wavelength, subwavelength localization is possible within these metamaterial cavity structures. In the present paper, we show that the electromagnetic field is localized into a region of λ/8, where λ is the cavity resonance wavelength.
Open Access
Real-time and selective detection of single nucleotide DNA mutations using surface engineered microtoroids
(American Chemical Society, 2015) Toren, P.; Ozgur E.; Bayındır, Mehmet
Mictoroids, as optical biosensors, can provide beneficial biosensing platforms to understand DNA alterations. These alterations could have significant clinical importance, such as the case of Pseudomonas aeruginosa, which is a commonly found pathogen in Cystic Fibrosis (CF) patients-causing poor prognosis by undergoing mutations during disease steps, gaining virulence and drug resistance. To provide a preliminary diagnosis platform for early-stage bacterial mutations, biosensing with a selective microtoroid surface was suggested. For this purpose, microtoroids with high quality factors were fabricated. The microtoroid surfaces were coated with (3-aminopropyl) triethoxysilane (APTES)/trimethylmethoxysilane (TMMS) mixed silane solution followed by EDC/NHS chemistry for covalent conjugation of DNA probes. Ethanolamine capping was applied to avoid unspecific interactions. The confocal studies confirmed homogeneous functionalization of the microtoroid surface. The DNA hybridization was demonstrated to be affected from the probe length. The optical biosensors showed a significant response (∼22 pm) to the complementary strand of the mutated type P. aeruginosa DNA, while showing substantially low and late response (∼5 pm) to the point mismatch strand. The limit of detection (LOD) for the complementary strand was calculated as 2.32 nM. No significant response was obtained for the noncomplementary strand. The results showed the microtoroids possessed selective surfaces in terms of distinguishing DNA alterations.
Open Access
Ultrasensitive label-free microcavity biosensors with high selectivity
(IEEE, 2011) Özgür, Erol; Bayındır, Mehmet; Aktaş, Ozan
High quality factor whispering gallery mode microresonators have been recently shown to exhibit detection sensitivity of single molecule; however, the selectivity of these sensors among different types of analytes remains as an important issue, obscuring the broad applicability of optical microcavities. We demonstrate a surface modification strategy for fabrication of high selectivity and sensitivity microcavity biosensors in this study. © 2011 IEEE.