Browsing by Subject "Non-Linearity"

Now showing 1 - 4 of 4

Open Access
Metamaterial based telemetric strain sensing in different materials
(Optical Society of American (OSA), 2010) Melik, R.; Unal, E.; Perkgoz, N.K.; Puttlitz, C.; Demir, Hilmi Volkan
We present telemetric sensing of surface strains on different industrial materials using split-ring-resonator based metamaterials. For wireless strain sensing, we utilize metamaterial array architectures for high sensitivity and low nonlinearity-errors in strain sensing. In this work, telemetric strain measurements in three test materials of cast polyamide, derlin and polyamide are performed by observing operating frequency shift under mechanical deformation and these data are compared with commercially-available wired strain gauges. We demonstrate that hard material (cast polyamide) showed low slope in frequency shift vs. applied load (corresponding to high Young's modulus), while soft material (polyamide) exhibited high slope (low Young's modulus).
Open Access
Nonlinearity engineering of mode-locked fiber lasers: Similariton and soliton-similariton lasers
(IEEE, 2011) İlday F. Ömer; Öktem, Bülent; Ülgüdür, Coşkun
Fiber lasers are attractive with their simplicity, high powers and low cost. However, propagation of short pulses in optical fiber leads to nonlinear effects, which limit the technical performance. These effects drive rich dynamics, which is interesting from a fundamental perspective. The nonlinear waves community has unraveled the fascinating world of solitons and similaritons through experiments in fibers. This paper overviews the recent development of the soliton-similariton laser. The original similariton laser was the first to work with nonlinear effects, rather than minimizing or compensating them. In the soliton-similariton laser, the propagation is strongly nonlinear everywhere. © 2011 IEEE.
Open Access
Properties of a microjoule-class fiber oscillator mode-locked with a SESAM
(IEEE, 2011) Lecaplain, C.; Ortac, Bülend; MacHinet G.; Boullet J.; Baumgartl, M.; Schreiber, T.; Cormier, E.; Hideur, A.
Energy scaling of ultrafast Yb-doped fiber oscillators has experienced rapid progress largely driven by many applications that require high average power femtosecond pulses. The fundamental challenge for ultrafast fiber lasers relies on the control of excessive nonlinearity, which limits pulse energy. The development of all-normal dispersion laser cavities based on large-mode-area photonic crystal fibers (PCFs) has enabled significant energy scaling [1-3]. In particular, up to microjoule energy levels have been achieved from rod-type fiber-based oscillators [2-3]. In such lasers, pulse shaping is dominated by the strength of the mode-locking mechanism which determines the pulse properties. In this contribution, we report the generation of high-energy sub-picosecond pulses from a highly normal dispersion fiber laser featuring an Yb-doped rod-type PCF and a large-mode-area PCF [Fig.1(a)]. Passive mode-locking is achieved using saturable absorber mirrors (SAMs). We study the influence of the SAM parameters on performances obtained in this new class of fiber oscillators. The structures exhibit 20 % modulation depths and 500 fs relaxation time with resonant and antiresonant designs. The antiresonant SAM structures ensure absorption bandwidths 45 nm while the resonant structures exhibit 20 nm bandwidths. Stable mode locking with average powers as high as 15 μW at 15 MHz repetition rate, corresponding to microjoule energy level are obtained with all the structures. However, pulse properties and pulse shaping mechanism distinguish between resonant and antiresonant designs. Using a broadband antiresonant SAM leads to generation of highly-chirped pulses with 30 ps duration and 10 nm spectral width [Fig.1(b)]. The output pulses are extra-cavity dechirped down to 550 fs duration. By increasing the strength of the mode-locking mechanism through the combination of the SAM with the NPE process, we obtain shorter pulses with slightly boarder spectra. Indeed, the output pulse duration is decreased from 30 ps to 13 ps by adjusting the wave-plates settings. The dechirped pulse duration is then shortened to 450 fs. We note that the current laser performances are limited to 1 J by the available pump power. Using a resonant SAM structure, the output pulse duration is decreased to 7 ps [Fig.1(b)]. This pulse shortening results from the spectral filtering induced by the limited SAM bandwidth. All these results are in good agreement with numerical simulations which will be discussed in this communication. © 2011 IEEE.
Open Access
Vibration absorption using non-dissipative complex attachments with impacts and parametric stiffness
(Acoustical Society of America, 2009) Roveri, N.; Carcaterra, A.; Akay, A.
Studies on prototypical systems that consist of a set of complex attachments, coupled to a primary structure characterized by a single degree of freedom system, have shown that vibratory energy can be transported away from the primary through use of complex undamped resonators. Properties and use of these subsystems as by energy absorbers have also been proposed, particularly using attachments that consist of a large set of resonators. These ideas have been originally developed for linear systems and they provided insight into energy sharing phenomenon in large structures like ships, airplanes, and cars, where interior substructures interact with a master structure, e.g., the hull, the fuselage, or the car body. This paper examines the effects of nonlinearities that develop in the attachments, making them even more complex. Specifically, two different nonlinearities are considered: (1) Those generated by impacts that develop among the attached resonators, and (2) parametric effects produced by time-varying stiffness of the resonators. Both the impacts and the parametric effects improve the results obtained using linear oscillators in terms of inhibiting transported energy from returning to the primary structure. The results are indeed comparable with those obtained using linear oscillators but with special frequency distributions, as in the findings of some recent papers by the same authors. Numerically obtained results show how energy is confined among the attached oscillators. © 2009 Acoustical Society of America.