Browsing by Subject "Network coding"
Now showing 1 - 3 of 3
Results Per Page
Sort Options
Item Open Access Broadcast erasure channel with feedback: The two multicast case-Algorithms and bounds(IEEE, 2013) Onaran, Efe; Gatzianas, M.; Fragouli, C.We consider the single hop broadcast packet erasure channel (BPEC) with two multicast sessions (each of them destined to a different group of N users) and regularly available instantaneous receiver ACK/NACK feedback. Using the insight gained from recent work on BPEC with unicast and degraded messages [1], [2], we propose a virtual queue based session-mixing algorithm, which does not require knowledge of channel statistics and achieves capacity for N = 2 and iid erasures. Since the extension of this algorithm to N > 2 is not straightforward, we describe a simple algorithm which outperforms standard timesharing for arbitrary N and is actually asymptotically better than timesharing, for any finite N, as the erasure probability goes to zero. We finally provide, through an information-theoretic analysis, sufficient but not necessary asymptotic conditions between N and n (the number of transmissions) for which the achieved sum rate, under any coding scheme, is essentially identical to that of timesharing. © 2013 IEEE.Item Open Access Decoding strategies at the relay with physical-layer network coding(Institute of Electrical and Electronics Engineers, 2012) Bhat, U.; Duman, T. M.A two-way relay channel is considered where two users exchange information via a common relay in two transmission phases using physical-layer network coding (PNC). We consider an optimal decoding strategy at the relay to decode the network coded sequence during the first transmission phase, which is approximately implemented using a list decoding (LD) algorithm. The algorithm jointly decodes the codewords transmitted by the two users and sorts the L most likely pair of sequences in the order of decreasing a-posteriori probabilities, based on which, estimates of the most likely network coded sequences and the decoding results are obtained. Using several examples, it is observed that a lower complexity alternative, that jointly decodes the two transmitted codewords, has a performance similar to the LD based decoding and offers a near-optimal performance in terms of the error rates corresponding to the XOR of the two decoded sequences. To analyze the error rate at the relay, an analytical approximation of the word-error rate using the joint decoding (JD) scheme is evaluated over an AWGN channel using an approach that remains valid for the general case of two users adopting different codebooks and using different power levels. We further extend our study to frequency selective channels where two decoding approaches at the relay are investigated, namely; a trellis based joint channel detector/physical-layer network coded sequence decoder (JCD/PNCD) which is shown to offer a near-optimal performance, and a reduced complexity channel detection based on a linear receiver with minimum mean squared error (MMSE) criterion which is particularly useful where the number of channel taps is large.Item Open Access Design of LDPC codes for two-way relay systems with physical-layer network coding(IEEE, 2013) Tanc, A. K.; Duman, T. M.; Tepedelenlioglu, C.This letter presents low-density parity-check (LDPC) code design for two-way relay (TWR) systems employing physical-layer network coding (PLNC). We focus on relay decoding, and propose an empirical density evolution method for estimating the decoding threshold of the LDPC code ensemble. We utilize the proposed method in conjunction with a random walk optimization procedure to obtain good LDPC code degree distributions. Numerical results demonstrate that the specifically designed LDPC codes can attain improvements of about 0.3 dB over off-the-shelf LDPC codes (designed for point-to-point additive white Gaussian noise channels), i.e., it is new code designs are essential to optimize the performance of TWR systems.