Browsing by Subject "Glass substrates"

Now showing 1 - 3 of 3

Open Access
Lyotropic liquid-crystalline mesophase of lithium triflate-nonionic surfactant as gel electrolyte for graphene optical modulator
(American Chemical Society, 2023) Balci, F. M.; Balci, S.; Kocabas, C.; Dag, Ö.
Lithium salt (noncoordinating anions, such as lithium triflate (Ltf)) gel electrolytes may be key for the practical use of electrochemical devices. We introduce a new lyotropic liquid-crystalline (LLC) mesophase using Ltf, a small amount of water (as low as 1.3 water per Ltf), and nonionic surfactant (C18H37(OCH2CH2)10OH, C18E10). The LLC phase forms over a broad range of Ltf/C18E10 mole ratios, 2-18. The clear ethanol solution of the ingredients can be either directly spin-coated over a glass substrate to form a gel phase or it can be prepared as a gel by mixing Ltf, water, and C18E10. The mesophase leaches out surfactant molecules at low salt concentrations, but at a salt/surfactant mole ratio of above 8, the phase is homogeneous with a cubic mesostructure, fully transparent in the visible optical region, mechanically flexible, and an effective gel electrolyte. We have observed a large electrostatic doping on graphene with the Fermi energy level of ∼1.0 eV using Ltf-C18E10 gel electrolytes. The Ltf-based gels demonstrate better properties than commonly used ionic liquid electrolyte in graphene optical modulators. The stability of the new gel electrolytes and their superior performance make them suitable electrolytes for use in graphene-based optical modulators.
Open Access
Self-limiting low-temperature growth of crystalline AlN thin films by plasma-enhanced atomic layer deposition
(2012) Ozgit, C.; Donmez I.; Alevli, M.; Bıyıklı, Necmi
We report on the self-limiting growth and characterization of aluminum nitride (AlN) thin films. AlN films were deposited by plasma-enhanced atomic layer deposition on various substrates using trimethylaluminum (TMA) and ammonia (NH 3). At 185 °C, deposition rate saturated for TMA and NH 3 doses starting from 0.05 and 40 s, respectively. Saturative surface reactions between TMA and NH 3 resulted in a constant growth rate of ∼ 0.86 Å/cycle from 100 to 200 °C. Within this temperature range, film thickness increased linearly with the number of deposition cycles. At higher temperatures (≤ 225 °C) deposition rate increased with temperature. Chemical composition and bonding states of the films deposited at 185 °C were investigated by X-ray photoelectron spectroscopy. High resolution Al 2p and N 1s spectra confirmed the presence of AlN with peaks located at 73.02 and 396.07 eV, respectively. Films deposited at 185 °C were polycrystalline with a hexagonal wurtzite structure regardless of the substrate selection as determined by grazing incidence X-ray diffraction. High-resolution transmission electron microscopy images of the AlN thin films deposited on Si (100) and glass substrates revealed a microstructure consisting of nanometer sized crystallites. Films exhibited an optical band edge at ∼ 5.8 eV and an optical transmittance of > 95% in the visible region of the spectrum. © 2011 Elsevier B.V. All rights reserved.
Open Access
Synthesis and optical properties of Co and Zn-based metal oxide nanoparticle thin films
(Polish Academy of Sciences, 2017) Gungor, E.; Gungor, T.; Calıskan, D.; Özbay, Ekmel
ZnO, Co doped ZnO (ZnO:Co) and CoO thin films were deposited on glass substrates by using the spark discharge technique with Zn-Zn, Zn-Co and Co-Co metal electrodes (tips). The structural and optical properties of the films were characterized by X-ray diffraction, scanning electron microscopy measurements and UV-Vis spectrometry. Cubic phase reflection of CoO (200) was observed in the samples containing Co. The size of nanoparticles had varied between 38 nm and 200 nm in ZnO thin films. When Co electrode was used, spherical structure had deteriorated and clusters of particles, with smaller radii, were observed. In addition, when Co-Co electrode pairs were used, various cavities with different sizes were formed. Especially, it was observed that the optical transmittance had generally increased with the decreasing spark (charge) voltage, while increasing with the number of sparks. The Co-containing samples were green in color and it was observed that the loss of transmission appears in a specific region in the Co-doped ZnO thin films due to characteristic d-d transition of Co2+ ions. The thickness of the films had decreased with the increasing number of sparks. In addition, the band gap energy, Eg, evaluated by UV-Vis spectroscopy measurements has been shifted to higher wavelengths (red shift) for the ZnO:Co thin films.