Browsing by Subject "Circuit"

Now showing 1 - 2 of 2

Open Access
High Power CMUTs: design and experimental verification
(IEEE, 2012) Yamaner, F. Y.; Olcum, S.; Oguz, H. K.; Bozkurt, A.; Köymen, Hayrettin; Atalar, Abdullah
Capacitive micromachined ultrasonic transducers (CMUTs) have great potential to compete with piezoelectric transducers in high-power applications. As the output pressures increase, nonlinearity of CMUT must be reconsidered and optimization is required to reduce harmonic distortions. In this paper, we describe a design approach in which uncollapsed CMUT array elements are sized so as to operate at the maximum radiation impedance and have gap heights such that the generated electrostatic force can sustain a plate displacement with full swing at the given drive amplitude. The proposed design enables high output pressures and low harmonic distortions at the output. An equivalent circuit model of the array is used that accurately simulates the uncollapsed mode of operation. The model facilities the design of CMUT parameters for high-pressure output, without the intensive need for computationally involved FEM tools. The optimized design requires a relatively thick plate compared with a conventional CMUT plate. Thus, we used a silicon wafer as the CMUT plate. The fabrication process involves an anodic bonding process for bonding the silicon plate with the glass substrate. To eliminate the bias voltage, which may cause charging problems, the CMUT array is driven with large continuous wave signals at half of the resonant frequency. The fabricated arrays are tested in an oil tank by applying a 125-V peak 5-cycle burst sinusoidal signal at 1.44 MHz. The applied voltage is increased until the plate is about to touch the bottom electrode to get the maximum peak displacement. The observed pressure is about 1.8 MPa with −28 dBc second harmonic at the surface of the array.
Open Access
Simultaneously opening transmission channels with negative and positive phase velocities for the stacked subwavelength apertures in fishnet metamaterials with hybrid unit lattices
(S P I E - International Society for Optical Engineering, 2012-10-05) Cakmak, A. O.; Colak, E.; Özbay, Ekmel
Hybridization of the unit lattice along the propagation direction was demonstrated to produce a negative-phase-velocity transmission band in the absence of the contributions from the higher diffraction orders for a stacked metallic fishnet grid with subwavelength apertures. This extraordinary transmission band is governed by the stacked resonators. The hybridized unit lattice configurations are not just slight modifications of the configurations with homogenous unit lattices. The volumetric proportions of different dielectric media are a key factor in the partitioned unit lattice for the estimation of the stacking and coupling effects between the resonators. The contribution of the coupling mechanisms enhances the transmission results almost by the same factor for the investigated lattice separations along the propagation direction in hybrid unit cells while the densely stacked resonators yield much higher transmission results, both around the regarding extraordinary transmission band that is associated with the negative phase velocity. A positive-phase-velocity transmission band was also exhibited by the hybridized unit lattice configuration when combined with a cavity resonator. Experimental transmission results of the hybrid configuration supported the theoretical predictions. The hybrid configurations are scalable to the near-infrared regime.