Browsing by Author "Atabak, Mehrdad"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Open Access Investigation of lateral forces in dynamic mode using combined AFM/STM(Bilkent University, 2007) Atabak, MehrdadIn this Ph.D. work, we constructed a ¯ber optic interferometer based non-contact Atomic Force Microscope (nc-AFM) combined with Scanning Tunneling Micro- scope(STM) to study lateral force interactions on Si(111)-(77) surface. The in- terferometer has been built in such a way that its sensitivity surpasses that of the earlier versions used in normal force measurements. The improvement in the resolution of the interferometer has allowed us to use sub-Angstrom oscillation amplitudes to obtain quantitative lateral force measurements. We have observed single and double atomic steps on Si(111)-(77) surface in topography and lat- eral sti®ness images. This information allowed us to measure the lateral forces directly and quantitatively. We have also carried out lateral force-distance spec- troscopy experiments, in which we simultaneously measured the force gradient and tunneling current, as the sample is approached towards the tip. The lateral force?distance curves exhibit a sharp increase of the force gradient, just after the tunnel current starts to increase, while the sample is approaching to the tip. We observed only positive force gradients. In separate experiments, we imaged the Cu-TBPP molecules deposited on Cu(100) surface in normal and torsional mode in dynamic force microscope us- ing STM feedback, with a homemade tungsten cantilever. Our experiments have shown the possibility of manipulating molecules on surface using a vibrating can- tilever. However the forces involved in these experiments are not quantitatively measured due to limitations of the method.Item Open Access Scanning Hall probe microscopy (SHPM) using quartz crystal AFM feedback(American Scientific Publishers, 2007) Dede, Münir; Ürkmen, Koray; Girişen, Ö.; Atabak, Mehrdad; Oral, Ahmet; Farrer, I.; Ritchie, D.Scanning Hall Probe Microscopy (SHPM) is a quantitative and non-invasive technique for imaging localized surface magnetic field fluctuations such as ferromagnetic domains with high spatial and magnetic field resolution of ∼50 nm and 7 mG/Hz 1/2 at room temperature. In the SHPM technique, scanning tunneling microscope (STM) or atomic force microscope (AFM) feedback is used to keep the Hall sensor in close proximity of the sample surface. However, STM tracking SHPM requires conductive samples; therefore the insulating substrates have to be coated with a thin layer of gold. This constraint can be eliminated with the AFM feedback using sophisticated Hall probes that are integrated with AFM cantilevers. However it is very difficult to micro fabricate these sensors. In this work, we have eliminated the difficulty in the cantilever-Hall probe integration process, just by gluing a Hall Probe chip to a quartz crystal tuning fork force sensor. The Hall sensor chip is simply glued at the end of a 32.768 kHz or 100 kHz Quartz crystal, which is used as force sensor. An LT-SHPM system is used to scan the samples. The sensor assembly is dithered at the resonance frequency using a digital Phase Locked Loop circuit and frequency shifts are used for AFM tracking. SHPM electronics is modified to detect AFM topography and the frequency shift, along with the magnetic field image. Magnetic domains and topography of an Iron Garnet thin film crystal, NdFeB demagnetised magnet and hard disk samples are presented at room temperature. The performance is found to be comparable with the SHPM using STM feedback.