Browsing by Subject "Impedance cytometry"

Now showing 1 - 5 of 5

Open Access
Classification of dielectric microparticles by microwave impedance cytometry
(Cold Spring Harbor Laboratory, 2022-09-28) Hanay, M. Selim; Sarı, Burak; Tefek, Uzay
AbstractCoulter counters and impedance cytometry are commonly used for counting microscopic objects, such as cells and microparticles flowing in a liquid, as well as to obtain their size distribution. However, the ability of these techniques to provide simultaneous material information — via dielectric permittivity measurements — has been limited so far. The challenge stems from the fact that the signals generated by microparticles of identical size, but different material composition, are close to each other. The similarity in impedance signals arises because the material-dependent factor is determined mainly by the volume of aqueous solution displaced by the microparticles, rather than the microparticles themselves. To differentiate between materially distinct particles with similar geometry and size, another measurement mode needs to be implemented. Here, we describe a new microfluidics-based sensor that provides material classification between microparticles with similar sizes by integrating impedance cytometry with microwave resonator sensors on the same chip. While low-frequency impedance cytometry provides the geometric size of particles, the microwave sensor operating at three orders-of-magnitude higher frequency provides their electrical size. By combining these two measurements, the Clausius-Mossotti factors of microparticles can be calculated to serve as a differentiation parameter. In addition to distinguishing dielectric materials from cells and metals, we classified two different dielectric microparticles with similar sizes and electrical characteristics: polystyrene and soda lime glass, with 94% identification accuracy. The proposed technique can serve as an automated monitoring system for quality control of manufactured microparticles and facilitate environmental microplastic screening.
Open Access
High resolution dielectric characterization of single cells and microparticles using integrated microfluidic microwave sensors
(Institute of Electrical and Electronics Engineers, 2023-03-01) Seçme, Arda; Tefek, Uzay; Sarı, Burak; Pisheh, Hadi Sedaghat; Uslu, H. Dilara; Akbulut, Özge; Küçükoğlu, Berk; Erdogan, R. Tufan; Alhmoud, Hashim; Şahin, Özgür; Hanay, M. Selim
Microwave sensors can probe intrinsic material properties of analytes in a microfluidic channel at physiologically relevant ion concentrations. While microwave sensors have been used to detect single cells and microparticles in earlier studies, the synergistic use and comparative analysis of microwave sensors with optical microscopy for material classification and size tracking applications have been scarcely investigated so far. Here we combined microwave and optical sensing to differentiate microscale objects based on their dielectric properties. We designed and fabricated two types of planar sensor: a Coplanar Waveguide Resonator (CPW) and a Split-Ring Resonator (SRR). Both sensors possessed sensing electrodes with a narrow gap to detect single cells passing through a microfluidic channel integrated on the same chip. We also show that standalone microwave sensors can track the relative changes in cellular size in real-time. In sensing single 20-micron diameter polystyrene particles, Signal-to-Noise ratio values of approximately 100 for CPW and 70 for SRR sensors were obtained. These findings demonstrate that microwave sensing technology can serve as a complementary technique for single-cell biophysical experiments and microscale pollutant screening.
Open Access
Impedance-based viscoelastic flow cytometry
(WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim, 2019) Serhatlıoğlu, Murat; Asghari, Mohammad; Guler, M. T.; Elbuken, Çağlar
Elastic nature of the viscoelastic fluids induces lateral migration of particles into a single streamline and can be used by microfluidic based flow cytometry devices. In this study, we investigated focusing efficiency of polyethylene oxide based viscoelastic solutions at varying ionic concentration to demonstrate their use in impedimetric particle characterization systems. Rheological properties of the viscoelastic fluid and particle focusing performance are not affected by ionic concentration. We investigated the viscoelastic focusing dynamics using polystyrene (PS) beads and human red blood cells (RBCs) suspended in the viscoelastic fluid. Elasto‐inertial focusing of PS beads was achieved with the combination of inertial and viscoelastic effects. RBCs were aligned along the channel centerline in parachute shape which yielded consistent impedimetric signals. We compared our impedance‐based microfluidic flow cytometry results for RBCs and PS beads by analyzing particle transit time and peak amplitude at varying viscoelastic focusing conditions obtained at different flow rates. We showed that single orientation, single train focusing of nonspherical RBCs can be achieved with polyethylene oxide based viscoelastic solution that has been shown to be a good candidate as a carrier fluid for impedance cytometry.
Embargo
Microwave resonant sensor integration with impedance cytometry in microfluidic platform for probing micro-scale dielectric permittivity
(2023-09) Tefek, Uzay
This thesis presents a novel multiphysical sensor that integrates low-frequency impedance cytometry with high-frequency microwave capacitance sensing. The characterization of microscale objects, including microparticles and cells, is essential in various scientific disciplines, such as biology, materials science, and environmental science. Accurate identification and classification of these microscale entities are critical for applications ranging from drug delivery optimization to environmental impact assessment, however, the current techniques fall short in terms of the rapidity and cost-effectiveness necessary for analyzing extensive populations. To address this challenge, our hybrid sensor combines low-frequency impedance cytometry and high-frequency microwave capacitance sensing for material characterization based on dielectric permittivity. This integration offers a rapid, cost-effective, and highly accurate method for identifying and characterizing microscale particles and cells. Experimental studies demonstrate the sensor’s efficacy, achieving remarkable signal-to-noise ratios. The sensor’s versatility ex-tends monitoring permittivity changes in single cells exposed to fixing agents offering valuable insights into cellular properties. In summary, this thesis introduces an innovative multiphysical sensor that advances microscale entity analysis, enabling rapid and precise identification and characterization.
Open Access
Permittivity-based classification by the integration of impedance cytometry and microwave sensing
(IEEE - Institute of Electrical and Electronics Engineers, 2023-11-07) Tefek, Uzay; Sarı, B.; Alhmoud, Hashim; Hanay, Mehmet Selim
The direct determination of the permittivity of individual micro-objects has proven challenging due to the convoluting effect of their geometric size on capacitive signals (i.e., on the electric size of a particle). To overcome this challenge, we have developed a sensing platform to independently obtain both the geometric and electric size of organic and inorganic particles, by combining impedance cytometry and microwave resonant sensing in a microfluidic chip. This way the microwave signal is normalized to yield an intrinsic parameter that depends only on permittivity. The permittivity can then be used for material classification or single-cell interrogation.